Skip to main content

Changes to Step #6

Edit by Cliff Harris

等待批准

Deleted
Added
Unchanged

Step Lines

[* black] Solder the core on to the opposite side to the shipchip (in the opposite corner).
[* black] Solder the core on to the opposite side to the shipchip (in the opposite corner).
[* black] Cut two pieces of the smallest heatshrink - roughly 4mm long.
[* black] Slide on to the braid leaving roughly 3mm of braid free at the end where it joins the cable.
[* black] Shrink in to place. If your heat gun is a bit powerful, use the soldering iron to supply the heat.
[* black] Cut off the braids leaving about 3mm free beyond the heatshrink.
[* black] Solder the first braid on to the chip side in the opposite corner to the chip.