跳到步骤＃4
由 Craig Lloyd — 编辑
编辑已通过 由 Craig Lloyd
- 之前
- 之后
- 不变
步骤行
| - | [* black] The adhesive is so strong we needed sEvEN hUnDreD iOpENerS |
|---|---|
| - | [* black] Double stacking technique! More effective? Questionable... |
| - | [* black] We considered using the mass amounts of torque generated by our [link|https://www.ifixit.com/News/48944/heres-why-ps5-joysticks-drift-and-why-theyll-only-get-worse|drifting DualSense controller joysticks] to get the rear panel off, but we decided to use our trusty suction cup and opening pick instead. |
| + | [* black] Like a physician terrible at their job (or great at their job?), we take one quick look and immediately prescribe the annual dose of heat and slicing to get the rear panel off. |
| + | [* icon_note] Perhaps doubling down on the dosage of iOpeners will make our jobs a bit easier? We might need to perform more medical trials, but doesn't hurt to try this time. |
| + | [* black] After bringing in the big [heat] guns, the only thing left to do was making our incisions around the perimeter. |
| + | [* icon_note] The new camera bezel design makes this part a bit tricky along the right edge of the phone, but a minor detour with our opening pick takes care of that. |