跳转到主内容

跳到步骤#1

Sean Gardner编辑

编辑已通过 由 Sean Gardner

已删除
已添加
不变

步骤行

[* red] Using a phillipsPhillips #2 screwdriver, remove the two screws holding(circled in red) attaching the fan assembly ontoto the unit.
[* black] Carefully unplugdisconnect the fan connector from the socket, as depicted in the second picture.
[* icon_note] The controller connector panel can be gently pulled up (GENTLY) fromout of the main unit and laid down, as depicted. This is not strictly required, but may provide more maneuverability inside the case.
[* icon_caution] While removing the fan makeMake sure to NOTnot pull out the wireswires while removing the fan. Doing so may damage the connector wire or the PCB.
[* red] Using a phillipsPhillips #2 screwdriver, remove the two screws holding(circled in red) attaching the fan assembly ontoto the unit.
[* black] Carefully unplugdisconnect the fan connector from the socket, as depicted in the second picture.
[* icon_note] The controller connector panel can be gently pulled up (GENTLY) fromout of the main unit and laid down, as depicted. This is not strictly required, but may provide more maneuverability inside the case.
[* icon_caution] While removing the fan makeMake sure to NOTnot pull out the wireswires while removing the fan. Doing so may damage the connector wire or the PCB.