跳转到主内容

跳到步骤#1

Lauren编辑

编辑已通过 由 Lauren

已删除
已添加
不变

步骤行

[* red] Using a phillips #2 screwdriver, remove the two screws holding the fan assembly onto the unit.
[* black] Carefully unplug the fan connector from the socket, depicted in the second picture.
[* icon_note] The controller connector panel can be pulled up (GENTLY) from the main unit and laid down, as depicted. This is not strictly required, but may provide more maneuverability inside the case.
[* black] Remove the two screws holdingicon_caution] While removing the fan assembly onto the unit using a Philips #2 screwdriver as shown.
[* black] Carefully unplug the fan connector from the socket.
[* icon_caution] DO
make sure to NOT pull out the wires to disconnect the fan! The picture shown is intended only to illustrate the connector in question. Pulling the wireswires. Doing so may damage the connector, the wires,connector wire or even the PCB.
[* black] Remove the two screws holdingicon_caution] While removing the fan assembly onto the unit using a Philips #2 screwdriver as shown.
[* black] Carefully unplug the fan connector from the socket.
[* icon_caution] DO
make sure to NOT pull out the wires to disconnect the fan! The picture shown is intended only to illustrate the connector in question. Pulling the wireswires. Doing so may damage the connector, the wires,connector wire or even the PCB.