跳转到主内容

跳到步骤#1

Jerry F Nerviano编辑

等待批准

已删除
已添加
不变

步骤行

[* icon_note] The controller connector panel can be pulled up (GENTLY) from the main unit and laid down, as depicted. This is not strictly required, but may provide more maneuverability inside the case.
[*
black] UnscrewRemove the two screws holding the fan assembly onto the unit using a Philips #2 screwdriver as shown.
[* black] Carefully unplug the tanfan connector from the socket. Do not
[* icon_caution] DO NOT
pull on the wires (as shown), but pull onto disconnect the fan! The picture shown is intended only to illustrate the connector itselfin question. Pulling the wires may damage the connector, the wires, or even the PCB.
[* icon_note] The controller connector panel can be pulled up (GENTLY) from the main unit and laid down, as depicted. This is not strictly required, but may provide more maneuverability inside the case.
[*
black] UnscrewRemove the two screws holding the fan assembly onto the unit using a Philips #2 screwdriver as shown.
[* black] Carefully unplug the tanfan connector from the socket. Do not
[* icon_caution] DO NOT
pull on the wires (as shown), but pull onto disconnect the fan! The picture shown is intended only to illustrate the connector itselfin question. Pulling the wires may damage the connector, the wires, or even the PCB.