跳转到主内容

跳到步骤#4

Jeff Suovanen编辑

编辑已通过 由 Jeff Suovanen

之前
之后
不变

步骤行

+[* black] Apply heat to the left edge of the iPad for about two minutes, or until it's slightly too hot to touch comfortably.
+ [* black] If necessary, re-heat your iOpener for a few seconds or until it's a bit too hot to touch. Be careful not to overheat the iOpener, or it may burst.
[* black] Insert a second opening pick at the bottom left corner of the iPad.
-[* icon_caution] Take especially care that you don't insert the opening between the actual display and the front glas panel.
-[* black] Slide the second opening pick down the left side of the display.
-[* black] Move the opening pick into the top left corner of the iPad where the headphone jack is located and leave it there.
+[* black] Slide the second opening pick along the left side of the display to separate the adhesive underneath.
+[* black] Leave the opening pick inserted near the top left corner of the iPad to prevent the adhesive from re-sealing.

图片1

旧版本

新版本

图片2

旧版本

新版本