跳转到主内容

跳到步骤#2

Dominik Schnabelrauch编辑

编辑已通过 由 Dominik Schnabelrauch

之前
之后
不变

步骤行

+[* black] Place a suction cup next to the iPad's home button and press down to create a seal.
+ [* icon_note] To get the most leverage, place the suction cup as close to the edge as possible without going past the edge of the display.
+[* black] Firmly pull up on the suction cup to to create a small gap between the front panel and the rear case.
+[* icon_caution] Do not pull too hard or you may shatter the glass.
+[* black] Once you've opened a sufficient gap, insert an opening pick into the gap to prevent the adhesive from resealing.
+[* black] Slide the pick along the edge of the display, towards the bottom left corner and leave it there to prevent the adhesive from resealing.

图片1

没有之前的图片

已添加

图片2

没有之前的图片

已添加