跳转到主内容

跳到步骤#2

Jeff Suovanen编辑

编辑已通过 由 Jeff Suovanen

之前
之后
不变

步骤行

[* black] Place a suction cup next to the iPad's home button and press down to create a seal.
[* icon_note] To get the most leverage, place the suction cup as close to the edge as possible without going past the edge of the display.
[* black] Firmly pull up on the suction cup to to create a small gap between the front panel and the rear case.
-[* icon_caution] Do not pull too hard or you may shatter the glass.
-[* black] Once you've opened a sufficient gap, insert an opening pick into the gap to prevent the adhesive from resealing.
-[* black] Slide the pick along the edge of the display, towards the bottom left corner and leave it there to prevent the adhesive from resealing.
+ [* icon_caution] Don't pull too hard, or you may shatter the glass. If necessary, apply more heat to further soften the adhesive.
+ [* icon_note] If your iPad's screen is badly cracked, covering it with a smooth layer of clear packing tape may help the suction cup adhere. Alternatively, use a strong piece of tape (such as duct tape) and [https://d3nevzfk7ii3be.cloudfront.net/igi/NgVMfmOgJwEalMFF.huge|fold it into a handle|new_window=true].
+[* black] Once you've opened a sufficient gap, insert an opening pick into the gap.

图片2

已删除