跳转到主内容

跳到步骤#6

Kristin Villanueva编辑

编辑已通过 由 Kristin Villanueva

已删除
已添加
不变

步骤行

[* black] Remove the eight 11mm screws from the central pillar using a Phillips #1 screwdriver.
[* black] Pull apart the two sides of the central pillar at the toptop using two hands. They will not separate completely at the bottom.
[* black] Pull apart the two sides of the central pillar at the toptop using two hands. They will not separate completely at the bottom.
[* black] With the two halves partially separated, remove the rubber wheel.
[* icon_caution] A small black rectangular piece may fall out of the chute when the halves are separated. Reattach this by reaching into the chute and putting the pins from the piece into the holes on the side of the chute.