跳转到主内容

跳到步骤#6

Travis Lamb编辑

编辑已通过 由 Travis Lamb

已删除
已添加
不变

步骤行

[* blackred] Remove the eight 11mm screws from the central pillar using a Phillips #1 screwdriver.
[* blackred] Remove the eight 11mm screws from the central pillar using a Phillips #1 screwdriver.
[* black] Pull apart the two sides of the central pillar at the top by using both hands. The two sides will not completely separate at the base.
[* black] With the two halves partially separated, remove the rubber wheel with your hand.
[* icon_caution] A small black rectangular piece may fall out of the chute when the halves are separated. Reattach this by reaching into the chute and putting the pins from the piece into the holes on the side of the chute.

图片1

旧版本

新版本