跳转到主内容

跳到步骤#4

Alec M编辑

编辑已通过 由 Alec M

之前
之后
不变

步骤行

[title] Lift and remove the rear panel
[* icon_caution] When lifting the panel, make sure not to lift it too high, since you'll run the risk of tearing the cable, or damaging the connector on the board.
[* blue] Flip the lock on the flex cable connector up with a spudger.
-[* black] The front panel should pop off now that the cable has been disconnected.
+[* black] The front panel should pop off, now that the cable has been disconnected.
[* icon_note] When reassembling the device, make sure to insert the left side of the front panel first, since it has a small lip that needs to fit under the left part of the camera case.