跳转到主内容

修复你的物品

维修的权力

商店

跳到步骤#2

Reed Breuer编辑

编辑已通过 由 Reed Breuer

之前
之后
不变

步骤行

[* black] With the axle nut off you can now slide the wheel on and off. Depending on your set up there could be two small washers, one that goes on the axle before the wheel and one after the wheel.
[* black] To remove the bearings and bearing spacer from the wheelwheel, first slide the wheel so that it is half off the edge of the truck axle.
[* black] With the axle nut off you can now slide the wheel on and off. Depending on your set up there could be two small washers, one that goes on the axle before the wheel and one after the wheel.
[* black] To remove the bearings and bearing spacer from the wheelwheel, first slide the wheel so that it is half off the edge of the truck axle.
[* black] Then pry the bearing that is still on the axle by prying the wheel about the end of the axle. The bearing should pop out and the bearing spacer that is loose inside will fall out after it.
[* black] Flip the wheel around and pry out the other bearing in the same manner.