跳转到主内容

跳到步骤#2

Daniel编辑

编辑已通过 由 Daniel

之前
之后
不变

步骤行

-[* black] With the axel nut off you can now slide the wheel on and off.
+[* black] With the axel nut off you can now slide the wheel on and off. Depending on your set up there could be two small washers one that goes on the axel before the wheel and after the wheel.
[* black] To remove the bearings and bearing spacer from the wheel first slide the wheel so that it is half off the edge of the truck axel.
[* black] Then pry the bearing that is still on the axel by rotating the wheel about the end of the axel. The bearing should pop out and the bearing spacer that is loose inside will fall out after it.
[* black] Flip the wheel around and pry out the other bearing in the same manner.