跳转到主内容

跳到步骤#2

Tarun Thiruma编辑

编辑已通过 由 Tarun Thiruma

之前
之后
不变

步骤行

[title] Release the Screen Assembly
-[* black] Apply a suction cup to the right edge of the display as close as possible to the bottom of the device without overlapping the fingerprint sensor.
-[* black] Pull up on the suction cup with firm, constant pressure to create a slight gap along the bottom edge between the screen assembly and rear case.
- [* icon_note] This may require a significant amount of force, but you only need to open a very slight gap with the suction cup to insert your tool.
- [* icon_caution] As the display on top of the screen assembly is flexible, you may end up separating the right edge of the display from the screen assembly instead of lifting the entire assembly. Try to pull up just the bottom edge of the screen assembly to prevent warping the display.
- [* icon_note] If you have trouble, apply more heat to further soften the adhesive, and try again. The adhesive cools quickly, so you may need to heat it repeatedly.
-[* black] Insert an opening pick into the gap you opened behind the screen assembly.
-[* icon_note] Ensure your tool is behind the entire screen assembly and not just the display. You should notice a small [https://d3nevzfk7ii3be.cloudfront.net/igi/KkMOORBHd5kCf4Om.full|plastic tab|new_window=true] unclip from the device's frame if you have done this correctly.
+[* black] Insert a jimmy or other metal tool between the right side of the plastic display and the metal frame, near the phone's side buttons.
+ [* icon_note] This may require a considerable amount of force. Push the tool as far down into the gap as you can, taking care to not scratch the chassis of your device in the process.
+[* black] Tilt the jimmy downward while simultaneously continuing to push it deeper into the gap to pry up the right side of the screen assembly.
+ [* icon_caution] As the display on top of the screen assembly is flexible and only attached with a slight amount of adhesive, you may end up only prying up the display from the screen assembly instead of lifting the entire assembly. If this occurs, remove the tool and try again, this time using more downward force to get underneath the entire assembly.
+[* icon_note] Ensure your tool is behind the entire screen assembly and not just the display. You should notice the thin silver metal midframe come up with the plastic display (as shown) if you have done this correctly.

图片1

旧版本

新版本

图片2

旧版本

新版本

图片3

旧版本

新版本