跳转到主内容

跳到步骤#2

Tarun Thiruma编辑

编辑已通过 由 Tarun Thiruma

之前
之后
不变

步骤行

-[* black] Wedge the plastic opening tool between the gap created by separating the screen and body of the phone in the right hand corner to hold it open.
-[* black] Insert the nylon spudger into the lower left corner of the screen and pry the screen toward you.
-[* black] Continue to insert the plastic opening and spudger tools around the phone, and pry open the screen until it is fully separated from the device.
-[* icon_caution] It is possible to pry the display assembly apart at this step. Be sure to get the prying instruments underneath both the LCD and screen layers of the display assembly to ensure this separation does not occur.
+[title] Release the Screen Assembly
+[* black] Apply a suction cup to the right edge of the display as close as possible to the bottom of the device without overlapping the fingerprint sensor.
+[* black] Pull up on the suction cup with firm, constant pressure to create a slight gap along the bottom edge between the screen assembly and rear case.
+ [* icon_note] This may require a significant amount of force, but you only need to open a very slight gap with the suction cup to insert your tool.
+ [* icon_caution] As the display on top of the screen assembly is flexible, you may end up separating the right edge of the display from the screen assembly instead of lifting the entire assembly. Try to pull up just the bottom edge of the screen assembly to prevent warping the display.
+ [* icon_note] If you have trouble, apply more heat to further soften the adhesive, and try again. The adhesive cools quickly, so you may need to heat it repeatedly.
+[* black] Insert an opening pick into the gap you opened behind the screen assembly.
+[* icon_note] Ensure your tool is behind the entire screen assembly and not just the display. You should notice a small [https://d3nevzfk7ii3be.cloudfront.net/igi/KkMOORBHd5kCf4Om.full|plastic tab|new_window=true] unclip from the device's frame if you have done this correctly.

图片1

旧版本

新版本

图片2

旧版本

新版本

图片3

旧版本

新版本