跳转到主内容

修复你的物品

维修的权力

商店

跳到步骤#2

101 Tech USA编辑

编辑已通过 由 101 Tech USA

之前
之后
不变

步骤行

[* black] Put the wire harness back in place by sliding the lower portion down into the slot in the gearbox, then pushing the top end back down. There is a round hole in the harness that corresponds to a small peg in the gearbox. Don't forget to hook the trigger plunger spring back onto its post.
[* blackgreen] Reinstall the small screw that holds the wire harness in place.
[* blackyellow] Make sure the trigger spring is attached to the trigger as shown.
[* blackgreen] Reinstall the small screw that holds the wire harness in place.
[* blackyellow] Make sure the trigger spring is attached to the trigger as shown.

图片2

旧版本

新版本

图片3

旧版本

新版本