跳转到主内容

修复你的物品

维修的权力

商店

跳转至iPad 3 Wi-Fi Adhesive Strips Replacement简介

Jeff Suovanen编辑

编辑已通过 由 Jeff Suovanen

之前
之后
不变
Introduction
replace the adhesive strips and re-seal on your iPad 3 after Wi-Fi to seal the deal on a repair. repair job well done. [ … ] '''Only for use with EXISTINGBefore you begin peeling and sticking tape, it's important to have clean adhesion surfaces on both the front panel assemblies.''' and the rear case. Use a spudger to scrape off any large excess bits of original adhesive, then clean all of the gluing surfaces with a paper towel and rubbing alcohol or Goof Off. [ ] It is recommended that you peel each adhesive strip as needed, rather than lay them out all at once.
replace the adhesive strips and re-seal on your iPad 3 after Wi-Fi to seal the deal on a repair. repair job well done. [ … ] '''Only for use with EXISTINGBefore you begin peeling and sticking tape, it's important to have clean adhesion surfaces on both the front panel assemblies.''' and the rear case. Use a spudger to scrape off any large excess bits of original adhesive, then clean all of the gluing surfaces with a paper towel and rubbing alcohol or Goof Off. [ ] It is recommended that you peel each adhesive strip as needed, rather than lay them out all at once.

指南的前提条件

工具

  • iFixit Opening Tools x1 removed.
  • Spudger x1 removed.
  • Phillips #00 Screwdriver x1 removed.