跳转到主内容

跳转至AXIS 213 PTZ Network Camera Capacitor Replacement简介

Stefan Van pellicom编辑

编辑已通过 由 Stefan Van pellicom

之前
之后
不变
Introduction
A lot of these camera's seem to come down with a '''"NO VIDEO" error''' in the upper left corner of the preview window. This is due to the failure of one or more capacitors on one of the video module's interface boards. Probably due to a combination of rather high temperature inside, and many years of use.
As itIt is hard to determine exactly which capacitor is involved,. But knowing that any one of the others might fail next, and knowing the components come at 2 cents each, it is better to replace the lot ...
The soldering is not for the faint hearted, and requires much more than entry level experience !! You may want to prepare everything, and seek help for the final soldering step ...
Time Required Min
1小时
Time Required Max
1小时
Difficulty
Moderate
Difficult

工具

  • Phillips #0 Screwdriver x1 added.
  • Tweezers x1 added.
  • Flush Cutter x1 added.

配件

  • As mentioned in step 13 x1 added.