1. To remove the lens, three T15 x 12.5mm screws must be removed by a T15 head screwdriver.
    • To remove the lens, three T15 x 12.5mm screws must be removed by a T15 head screwdriver.

    • The location of the other two screws are marked in red.

    添加评论

  2. After the lens has been removed the back cover needs to be removed. There are no snaps or screws holding it in place.
    • After the lens has been removed the back cover needs to be removed. There are no snaps or screws holding it in place.

    添加评论

    • Remove battery by unplugging it from the circuit board.

    添加评论

    • Remove the circuit board by pressing on the mounting clips (shown in red circles) using the spudger.

    添加评论

    • Desolder the wires to free the circuit board.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Jeremiah Rhoades

于2017年11月07日注册

365 信誉积分

创作了3篇指南

团队

IUPUI, Team S2-G3, Harley Fall 2017 IUPUI, Team S2-G3, Harley Fall 2017 的会员

IUPUI-HARLEY-F17S2G3

3 名成员

创作了3篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 12

总计 175