简介

The button on the device's back may sometimes become damaged or dirty and therefore need replacement. This guide will go over how to access the back button's contact in order to clean or replace.

Using the Triangle driver remove the four 7.5 mm screws.
  • Using the Triangle driver remove the four 7.5 mm screws.

  • The two front screws are deeper than the two on the back legs which may cause difficulties. These can be reached by putting the bit in first then carefully putting the driver on slightly (not all the way)

添加评论

Turn the device so that the the device is on its side.
  • Turn the device so that the the device is on its side.

  • Hold the back and belly on the device and gently pull apart.

  • Pulling with too much force might damage a few cables inside, so caution is needed.

添加评论

  • With insides exposed, grab leg and gently pull up and away from the body to detach them. Repeat for all legs needed.

添加评论

  • Locate the gray rubber contact in the middle of the bottom half of the device. Using the spudger, lift one corner of the contact until it pops loose.

  • Grab the contact and gently pull until the other side detaches.

  • When replacing the contact pad, use the narrow leads on the pad to pull it into place by twisting around the tips of the tweezers.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Mitchell Gentry

于2018年02月14日注册

651 信誉积分

创作了6篇指南

团队

USF Tampa, Team S6-G2, Eyestone Spring 2018 USF Tampa, Team S6-G2, Eyestone Spring 2018 的会员

USFT-EYESTONE-S18S6G2

3 名成员

创作了8篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 2

过去的30天: 2

总计 30