跳转到主内容

修复你的物品

维修的权力

配件 & 工具

简介

This guide involves taking apart the Zoomer Dino Boomer in order to disconnect the sensor button from the main circuit board for replacement.

  1. Power off Zoomer Dino Boomer before disassembly.
    • Power off Zoomer Dino Boomer before disassembly.

    • Remove the eight 9.3mm Phillips #1 screws.

  2. Turn dinosaur over and hold upright. Use the spudger to pry apart the back cover from the remainder of the Zoomer Dino Boomer.
    • Turn dinosaur over and hold upright.

    • Use the spudger to pry apart the back cover from the remainder of the Zoomer Dino Boomer.

    • Be gentle while removing the back cover. The back cover of the Zoomer Dino Boomer is still connected to the electronic system by a wire.

  3. 任天堂 Switch 套装

    快速恢复到游戏的状态

    购买 Switch 套装

    任天堂 Switch 套装

    快速恢复到游戏的状态

    购买 Switch 套装
  4. Disconnect the wire that connects the back cover of the dino to the main circuit board by carefully pulling on the orange wire connector with tweezers. Remove back cover. If you are having difficulty removing the connector from its socket, push in the small tabs on the side of the connector with the tweezers. This step may take some work.
    • Disconnect the wire that connects the back cover of the dino to the main circuit board by carefully pulling on the orange wire connector with tweezers.

    • Remove back cover.

    • If you are having difficulty removing the connector from its socket, push in the small tabs on the side of the connector with the tweezers. This step may take some work.

    • Do not damage the wires or circuit board.

  5. Where the button is largest, squeeze the two white tabs together.
    • Where the button is largest, squeeze the two white tabs together.

  6. Push in the white circular piece between these tabs as far as it will go.
    • Push in the white circular piece between these tabs as far as it will go.

  7. Where the button is smallest, squeeze the two white tabs together and press the circular tab in-between them until the button comes loose. Remove the back button.
    • Where the button is smallest, squeeze the two white tabs together and press the circular tab in-between them until the button comes loose.

    • Remove the back button.

结论

To reassemble your device, follow these instructions in reverse order.

Lauren Mannix

于2015年08月29日注册

392 信誉积分

创作了3篇指南

团队

USF Tampa, Team 16-1, Wollert Fall 2015 USF Tampa, Team 16-1, Wollert Fall 2015 的会员

USFT-WOLLERT-F15S16G1

3 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 3

过去的30天: 22

总计 1,551