简介

If your toast rack does not slide up all the way, or your toast pops up too fast, try replacing the slide assist plunger with this guide.

  1. Using a wedge, pry off the rubber pieces on the bottom of each foot of the toaster.
    • Using a wedge, pry off the rubber pieces on the bottom of each foot of the toaster.

  2. Remove the eight 8mm screws on each toaster foot using a Tri-point Y1 screwdriver.
    • Remove the eight 8mm screws on each toaster foot using a Tri-point Y1 screwdriver.

  3. Remove the crumb collector located on the bottom of the toaster.
    • Remove the crumb collector located on the bottom of the toaster.

  4. Remove the three 8mm screws using the Tri-point Y1 screwdriver.
    • Remove the three 8mm screws using the Tri-point Y1 screwdriver.

  5. 所有超过US$100或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店
  6. Remove the two 8mm screws on the bottom of the slide lever using a Tri-point Y1 screwdriver.
    • Remove the two 8mm screws on the bottom of the slide lever using a Tri-point Y1 screwdriver.

    • Once the screws are removed, detach the black plastic cover on the bottom of the slide lever.

  7. Remove the final 8mm screw in the slide lever.
    • Remove the final 8mm screw in the slide lever.

    • The lever can now pull away from the entire unit.

  8. Remove toaster's outer shell by lifting straight up.
    • Remove toaster's outer shell by lifting straight up.

    • Slowly remove the outer shell. Disconnect ground wire before fully separating the shell and inner components.

  9. Disconnect the wire cluster that connects the lights and circuit board by pulling apart the two plastic connectors. Remove the outer shell from the device.
    • Disconnect the wire cluster that connects the lights and circuit board by pulling apart the two plastic connectors.

    • Remove the outer shell from the device.

  10. Remove the top panel by bending the tabs on each side straight up.
    • Remove the top panel by bending the tabs on each side straight up.

  11. Remove the two 8mm screws on the bottom of the plunger using a Tri-point Y1 screwdriver.
    • Remove the two 8mm screws on the bottom of the plunger using a Tri-point Y1 screwdriver.

  12. Remove the plunger from the device. Remove the plunger from the device.
    • Remove the plunger from the device.

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Ryan Funchess

于2018年04月19日注册

697 信誉积分

创作了5篇指南

团队

Cal Poly, Team S22-G5, Maness Spring 2018 Cal Poly, Team S22-G5, Maness Spring 2018 的会员

CPSU-MANESS-S18S22G5

4 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 59