Wolf Gourmet WGBL100S Control Board Replacement

简介

If your blender does not operate, try opening it as per this guide and checking the wires on the control board. If that yields no results, consider replacing the board if possible.

你所需要的

步骤 1 Control Board

Wolf Gourmet WGBL100S Control Board Replacement, Control Board: 步骤 1 中的图像 1，2

Wolf Gourmet WGBL100S Control Board Replacement, Control Board: 步骤 1 中的图像 2，2

Flip the base of the blender upside-down.
Remove the four 1/2" long screws in the corners of the base using a Phillips #2 screwdriver.

翻译

步骤 2

Using the metal spudger, pry off one half of each rubber foot.
Note that one side of the foot is glued down; pry off the other side.

翻译

步骤 3

Using the same screwdriver, remove the next four 1/2" long screws in the holes under the feet.
Pull the base off of the blender.

翻译

步骤 4

Pull off the plastic housing.

翻译

步骤 5

Using the same Phillips #2 screwdriver, remove the two 3/4" long screws holding the control board in place.

翻译

步骤 6

Using pliers, pull off all the connectors on the top.

翻译

步骤 7

Pull or pry off the last connector block, then remove the control board.

翻译

结论

To reassemble your device, follow these instructions in reverse order.

作者

与5其他贡献者

Cole Gillespie

于04/19/18注册

476 声望

创作了2篇指南

徽章: 9

+ 6更多徽章

团队

Cal Poly, Team S25-G16, Maness Spring 2018 Cal Poly, Team S25-G16, Maness Spring 2018 的会员

CPSU-MANESS-S18S25G16

4 名成员

创作了5篇指南

Wolf Gourmet WGBL100S Control Board Replacement

简介

你所需要的

步骤 1 Control Board

添加评论

步骤 2

添加评论

步骤 3

添加评论

步骤 4

添加评论

步骤 5

添加评论

步骤 6

添加评论

步骤 7

添加评论

作者

Cole Gillespie

团队

Cal Poly, Team S25-G16, Maness Spring 2018 Cal Poly, Team S25-G16, Maness Spring 2018 的会员

0条评论

添加评论

嵌入本指南

预览