N-Strike Nite Finder EX-3 Wire Replacement Guide - iFixit 维修指南

简介

If the laser does not turn on and the batteries are in good condition, then this problem may be because of a faulty wire. In order to replace the faulty wire causing your N-Strike Nite Finder EX-3 problems, follow the steps in this guide.

你所需要的

步骤 1 Wire

N-Strike Nite Finder EX-3 Wire Replacement Guide, Wire: 步骤 1 中的图像 1，1

Place the blaster upside down on the table, and remove the screw in the bottom of the handle.
Remove the battery door and take the batteries out.

步骤 2

N-Strike Nite Finder EX-3 Wire Replacement Guide: 步骤 2 中的图像 1，3

N-Strike Nite Finder EX-3 Wire Replacement Guide: 步骤 2 中的图像 2，3

N-Strike Nite Finder EX-3 Wire Replacement Guide: 步骤 2 中的图像 3，3

Set the blaster on its side with the screws facing up (the blaster will be placed on its left side). Remove all 14 phillips head, 8.2 mm screws and set them aside.
Lift the side of the blaster to expose its internal parts.

步骤 3

N-Strike Nite Finder EX-3 Wire Replacement Guide: 步骤 3 中的图像 1，1

Visually inspect all the wires in order to find the break, fray, or any other problem.
Locate the end connections of the affected wire.

步骤 4

N-Strike Nite Finder EX-3 Wire Replacement Guide: 步骤 4 中的图像 1，1

Use a hot soldering iron to melt the solder at one end of the wire until the wire can be pulled free from the connection.
Repeat on the other end of the connection to remove the wire from the blaster.
(End points marked on image are for the black wire)

结论

To reassemble your device, follow these instructions in reverse order.

作者

与5其他贡献者

Kyle Schober

于02/24/14注册

640 声望

创作了5篇指南

+ 11更多徽章

团队

Michigan Tech, Team 5-8, Lauer Spring 2014 Michigan Tech, Team 5-8, Lauer Spring 2014 的会员

MTU-LAUER-S14S5G8

3 名成员

创作了13篇指南

0条评论

浏览统计数据:

过去 24 小时： 0

过去 7 天： 0

过去 30 天： 3

总计 911