Wahl Chrome Pro Motor Replacement

简介

The motor drives the clipper blades. Motors can wear out after extended use. Replacing a worn-out motor can extend the longevity of this device.

你所需要的

步骤 1 Case

Wahl Chrome Pro Motor Replacement, Case: 步骤 1 中的图像 1，1

Remove the two 5.0 mm JIS #1 screws to loosen the cutting blades.
Make sure your device is not connected to power before you begin.

翻译

步骤 2

Lift the bottom blade straight up from the device body to remove it.

翻译

步骤 3

Remove the three 9.0 mm JIS #1 screws attaching the base of the blade assembly to the body.

翻译

步骤 4

Lift the base of blade assembly straight up off of the body.

翻译

步骤 5

Remove the two 12.0 mm JIS #1 screws on the back of the device body.

翻译

步骤 6

Remove the 13.0 mm Phillips #2 screw on the side of the device body.
This screw is located on the opposite side of the body from the switch.

翻译

步骤 7

Remove the spring on the side of the body using tweezers.

翻译

步骤 8

Pry the body case off of the device using a spudger.

翻译

步骤 9 Motor

Wahl Chrome Pro Motor Replacement, Motor: 步骤 9 中的图像 1，1

Lift power cord tab (black wire) from slot on motor base.

翻译

步骤 10

Lift switch tab (teal wire) from slot on motor base.

翻译

步骤 11

Remove two 23.0 mm JIS #1 screws attaching motor base to device body.

翻译

步骤 12

Lift motor base straight up from device body to remove.

翻译

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

作者

与3其他贡献者

Ashley Dale

于11/09/17注册

285 声望

创作了2篇指南

徽章: 8

+ 5更多徽章

团队

IUPUI, Team S7-G3, Baechle Fall 2017 IUPUI, Team S7-G3, Baechle Fall 2017 的会员

IUPUI-BAECHLE-F17S7G3

3 名成员

创作了4篇指南

Wahl Chrome Pro Motor Replacement

简介

你所需要的

步骤 1 Case

添加评论

步骤 2

添加评论

步骤 3

添加评论

步骤 4

添加评论

步骤 5

添加评论

步骤 6

添加评论

步骤 7

添加评论

步骤 8

添加评论

步骤 9 Motor

添加评论

步骤 10

添加评论

步骤 11

添加评论

步骤 12

添加评论

作者

Ashley Dale

团队

IUPUI, Team S7-G3, Baechle Fall 2017 IUPUI, Team S7-G3, Baechle Fall 2017 的会员

0条评论

添加评论

嵌入本指南

预览