修复你的物品 社区 商店

Visual Land Prestige 7L Front Facing Camera Replacement

简介

If your camera is not working, you may need to replace it completely. Following this guide will allow you to do so.

你所需要的

  1. Visual Land Prestige 7L Front Facing Camera Replacement, Back Panel: 步骤 1 中的图像 1，2 Visual Land Prestige 7L Front Facing Camera Replacement, Back Panel: 步骤 1 中的图像 2，2

    • Remove the two 8mm Phillips Head screws located at the bottom of your device.

    编辑

  2. Visual Land Prestige 7L Front Facing Camera Replacement: 步骤 2 中的图像 1，3 Visual Land Prestige 7L Front Facing Camera Replacement: 步骤 2 中的图像 2，3 Visual Land Prestige 7L Front Facing Camera Replacement: 步骤 2 中的图像 3，3

    • Insert the spudger between the two pieces of the case around the media ports and pry them apart.

    • We found the best way to get the spudger inside the case was to insert in into the SD card slot. Be sure to only insert the spudger a shallow amount and be careful not to damage any of the inside of the device.

    • Finish unsnapping each plastic piece holding the device together along the bottom.

    编辑

  4. Visual Land Prestige 7L Front Facing Camera Replacement: 步骤 3 中的图像 1，3 Visual Land Prestige 7L Front Facing Camera Replacement: 步骤 3 中的图像 2，3 Visual Land Prestige 7L Front Facing Camera Replacement: 步骤 3 中的图像 3，3

    • Move the spudger down the rest of the case, separating each side, and finally the top.

    • Pull the back off and place it to the side.

    • Without a back panel for protection, be sure place your device on the table screen-side down to avoid damaging the internal circuitry.

    编辑

  5. Visual Land Prestige 7L Front Facing Camera Replacement, Front Facing Camera: 步骤 4 中的图像 1，2 Visual Land Prestige 7L Front Facing Camera Replacement, Front Facing Camera: 步骤 4 中的图像 2，2

    • Remove the adhesive padding.

    编辑

  6. Visual Land Prestige 7L Front Facing Camera Replacement: 步骤 5 中的图像 1，2 Visual Land Prestige 7L Front Facing Camera Replacement: 步骤 5 中的图像 2，2

    • Unclip the connector that attaches the camera to the motherboard.

    • For more information on unclipping connectors see this How To Guide

    • Do not pull on the camera until you're sure that it's unclipped, the gold connection will rip.

    • Gently pop the camera out of the connector and off the case.

    编辑
结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

作者

与3其他贡献者

Greg Azzalina

于01/28/15注册

263 声望

撰写一个指南

徽章: 10

+ 7更多徽章

团队

Penn State, Team 2-25, Kaschak Winter 2015 Penn State, Team 2-25, Kaschak Winter 2015 的会员

PSU-KASCHAK-W15S2G25

4 名成员

创作了4篇指南

0条评论

添加评论

浏览统计数据:

过去 24 小时： 0

过去 7 天： 0

过去 30 天： 1

总计 273