修复你的物品 社区 商店

Visioneer OneTouch 7400 USB Motor Replacement

简介

Use this guide to remove and replace the Visioneer OneTouch 7400 USB scanner motor.

你所需要的

  1. Visioneer OneTouch 7400 USB Motor Replacement, Outer Case: 步骤 1 中的图像 1，1

    • On the bottom of the scanner, remove the screw at the top left side.

    编辑

  2. Visioneer OneTouch 7400 USB Motor Replacement: 步骤 2 中的图像 1，2 Visioneer OneTouch 7400 USB Motor Replacement: 步骤 2 中的图像 2，2

    • Remove the rubber foot pad opposite the screw hole to expose a second screw hole.

    • Remove the screw beneath the foot-pad.

    编辑

  3. Visioneer OneTouch 7400 USB Motor Replacement: 步骤 3 中的图像 1，3 Visioneer OneTouch 7400 USB Motor Replacement: 步骤 3 中的图像 2，3 Visioneer OneTouch 7400 USB Motor Replacement: 步骤 3 中的图像 3，3

    • Rotate the scanner so the screw hole is located on the top left hand side.

    • Place the plastic opening tool between the top casement and bottom casement of scanner with the hook facing up.

    • Gently pry the two casements apart beginning above the screw hole and working your way around.

    • Note that the top and bottom casings are held together by a series of 6 tabs. There is one tab on each of the long sides of the scanner approximately 6 inches in from the corners. There are two tabs on each of the short sides of the scanner approximately 2.3 inches in from the corners. Use the spudger to unhook the tab from the top casement.

    编辑

  5. Visioneer OneTouch 7400 USB Motor Replacement: 步骤 4 中的图像 1，1

    • Separate the two casement pieces.

    编辑

  6. Visioneer OneTouch 7400 USB Motor Replacement, Motor: 步骤 5 中的图像 1，1

    • Carefully detach the wires from the motherboard, pulling slowly but firmly.

    编辑

  7. Visioneer OneTouch 7400 USB Motor Replacement: 步骤 6 中的图像 1，2 Visioneer OneTouch 7400 USB Motor Replacement: 步骤 6 中的图像 2，2

    • Remove the four screws holding the motor in place.

    • Note: the pictures hereafter shown are without the motherboard, but you do not have to remove the motherboard to access the motor.

    编辑

  8. Visioneer OneTouch 7400 USB Motor Replacement: 步骤 7 中的图像 1，1

    • Lift the motor out of the scanner.

    编辑
结论

To reassemble your device, follow these instructions in reverse order.

作者

与3其他贡献者

Jena

于10/18/13注册

608 声望

创作了6篇指南

徽章: 9

+ 6更多徽章

团队

University of Maine, Team 1-13, Diaz Fall 2013 University of Maine, Team 1-13, Diaz Fall 2013 的会员

UMAINE-DIAZ-F13S1G13

3 名成员

创作了17篇指南

0指南评论

添加评论

浏览统计数据:

过去 24 小时： 0

过去 7 天： 1

过去 30 天： 8

总计 381