Skip to main content

介绍

Use this guide if buttons are damaged or if button inputs are unresponsive. Button replacement may require replacement of motherboard. While working on this device, make sure that the device is powered off and not plugged into the wall, as this may cause electrostatic shock.

  1. Expose the battery compartment by removing the lower back cover of the device.
    • Expose the battery compartment by removing the lower back cover of the device.

    • Do this by holding the back side of the device upside down in your hands and applying pressure to the indented portion with both thumbs.

  2. Once the batteries are exposed, use your index finger to push the battery against the spring and pull up to dislodge the battery.
    • Once the batteries are exposed, use your index finger to push the battery against the spring and pull up to dislodge the battery.

    • Make sure to check for battery acid or other corrosive substances before touching the battery. If needed, use latex gloves to avoid skin irritation from battery acid.

  3. Android 维修工具包

    一个新的屏幕或电池就在一个套件之内。

    现在开始购物

    Android 维修工具包

    一个新的屏幕或电池就在一个套件之内。

    现在开始购物
  4. Remove the two 11.2 mm Philips #00 screws located on either side of the battery slots.
    • Remove the two 11.2 mm Philips #00 screws located on either side of the battery slots.

  5. The white front covering of the device is held to the yellow back covering by four clips. When separating the front and back cover, be careful not to separate the red and black wires which connect the batteries to the motherboard.
    • The white front covering of the device is held to the yellow back covering by four clips.

    • When separating the front and back cover, be careful not to separate the red and black wires which connect the batteries to the motherboard.

    • Insert the plastic opening tool into the seam between the front and back coverings to create a gap. The tools edge should point toward the front covering. Start from the bottom of the device and slide the tool around the seam until all clips have been separated from the tabs.

  6. When separating the motherboard from the front cover, be careful not to disconnect the two red wires which connect the speaker to the motherboard. Remove the two 6.8 mm Philips #00 screws located on the top left and right corners of the motherboard.
    • When separating the motherboard from the front cover, be careful not to disconnect the two red wires which connect the speaker to the motherboard.

    • Remove the two 6.8 mm Philips #00 screws located on the top left and right corners of the motherboard.

    • Gently lift the motherboard away from the speaker case.

    • Remove old buttons and place new buttons into the button slot.

    • If button issues continue after button replacement, refer to the motherboard replacement guide.

结论

To reassemble your device, follow these instructions in reverse order.

Melany Colon

于2015年08月31日注册

231 Reputation

创作了2篇指南

Team

USF Tampa, Team 6-3, Remmell Fall 2015 USF Tampa, Team 6-3, Remmell Fall 2015 的会员

USFT-REMMELL-F15S6G3

4 名成员

创作了7篇指南

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 111