跳转到主内容

修复你的物品

维修的权力

商店

  1. Begin by flipping over the transmitter, and removing the padding from the underside of it. This will reveal the screws to take apart the device. Begin by flipping over the transmitter, and removing the padding from the underside of it. This will reveal the screws to take apart the device.
    • Begin by flipping over the transmitter, and removing the padding from the underside of it. This will reveal the screws to take apart the device.

  2. Remove the screws ( 11.27mm Phillips head) and open up the transmitter to reveal the internal components. Carefully pry open the transmitter, and use caution when opening it up as to not sever the wire. Remove the screws ( 11.27mm Phillips head) and open up the transmitter to reveal the internal components. Carefully pry open the transmitter, and use caution when opening it up as to not sever the wire. Remove the screws ( 11.27mm Phillips head) and open up the transmitter to reveal the internal components. Carefully pry open the transmitter, and use caution when opening it up as to not sever the wire.
    • Remove the screws ( 11.27mm Phillips head) and open up the transmitter to reveal the internal components. Carefully pry open the transmitter, and use caution when opening it up as to not sever the wire.

  3. Remove the two screws (5.21mm Phillips head) on the board on the top half of the transmitter that is holding the charging pins. Remove the two screws (5.21mm Phillips head) on the board on the top half of the transmitter that is holding the charging pins.
    • Remove the two screws (5.21mm Phillips head) on the board on the top half of the transmitter that is holding the charging pins.

  4. Once the screws are removed, desolder the two wires from the board, and then remove it, and the charging pins with it. Take extreme caution when dealing with a soldering iron. Refer to the desoldering guide for tips. Note that for the purposes of this guide we simply clipped the wires connected to the board holding the charging pins.
    • Once the screws are removed, desolder the two wires from the board, and then remove it, and the charging pins with it.

    • Take extreme caution when dealing with a soldering iron. Refer to the desoldering guide for tips.

    • Note that for the purposes of this guide we simply clipped the wires connected to the board holding the charging pins.

结论

To reassemble your device, follow these instructions in reverse order.

Johnny Lofton

于2017年01月18日注册

807 信誉积分

创作了5篇指南

Where did you get the new contact pins?

Kenneth Roberts - 回复

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 7

过去的30天: 26

总计 1,089