简介

Before starting any removal or installation, remember to turn off the device and to remove it from the power source.

  1. Before repairing your laptop, power down the system, disconnect the charger if necessary and remove the battery.
    • Before repairing your laptop, power down the system, disconnect the charger if necessary and remove the battery.

    • Use the flat edge of the plastic opening tool to pry open the narrow plastic strip above the keyboard.

    添加评论

  2. Remove the three 3mm screws with a Phillips#00 Screwdriver.
    • Remove the three 3mm screws with a Phillips#00 Screwdriver.

    添加评论

    • Lift the keyboard away from the top side of the laptop.

    • Do not pull the keyboard away too hard. It is still connected by the fragile ribbon cable (shown in the red square).

    添加评论

    • Disconnect the keyboard cable that is still attached to the keyboard (Red).

    • Unlatch the fastener (green).

    • Using your hands, pull the keyboard connector out, not up.

    添加评论

    • Flip the laptop over to access the battery.

    • Remove battery by sliding fingers away from each other and lifting up the tab at the same time.

    添加评论

  3. 传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    传播 Fixmas 欢乐
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Remove the twelve 10mm screws with a Phillips #00 Head screwdriver.

    • Remove the Cover over the Hard Drive (Upper right in photo) and remove the four 10mm screws at the four corners.

    添加评论

    • Remove the three 4mm screws with a Phillips #00 Screwdriver.

    添加评论

    • Flip the laptop over so its in the right-side-up position.

    • Lift the grey plastic casing up and unhook any wires attached to the casing.

    • Remove the five 10mm screws, each with a label 'F10' next to them.

    添加评论

    • Disconnect the flat thin wire connecting the track pad to the motherboard by pulling it straight out.

    • Disconnect the thin red wire on the right side of the motherboard.

    添加评论

    • Remove the two 6mm screws with a Phillips #00 Screwdriver.

    添加评论

    • Disconnect the red and yellow wires connecting the fan to the motherboard by pulling the wires straight out.

    • Remove the fan.

    添加评论

    • Remove the following with a Phillips #00 Screwdriver:

      • Six 7mm Phillips Head screws

      • One 5 mm Phillips Head screw

    • Remove the LCD screen tab

    添加评论

    • A red wire connects the motherboard to the computer, so release the wire by pulling it straight out.

    • After all the screws are removed, lift the motherboard up and away from the earphone jacks that are located at the front of the laptop.

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Mike Kennedy

于2013年04月18日注册

118 信誉积分

创作了4篇指南

团队

Cal Poly, Team 2-21, Maness Spring 2013 Cal Poly, Team 2-21, Maness Spring 2013 的会员

CPSU-MANESS-S13S2G21

4 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 4

过去的30天: 20

总计 2,209