简介

Standard Keyboard with 10-key and touchpad with multi-touch control

  1. Turn the laptop off and remove all sources of power.
    • Turn the laptop off and remove all sources of power.

    • Flip the laptop over so that way the bottom is facing towards you.

    • Remove the two 6.6mm Phillips #0 screws from the battery.

    添加评论

  2. Pull the battery out of the laptop.
    • Pull the battery out of the laptop.

    添加评论

    • Remove the thirteen 6.6mm Phillips #0 screws on the back of the device.

    添加评论

    • Use a plastic opening tool to lift and remove the bottom panel.

    添加评论

    • Remove the six 2.3mm Phillips #0 screws from the motherboard.

    • Use a pair of tweezers to lift up the tab on the ZIF connector and pull out the ribbon cable.

    添加评论

    • Disconnect the wires from the motherboard.

    • Lift and remove the disk drive.

    • Lift and remove the hard drive.

    添加评论

    • Lift up the motherboard

    • Use tweezers to carefully peel apart IDE ribbon cables connected from motherboard to keyboard

    添加评论

    • Use a plastic opening tool to unlatch the keyboard from the device

    • Lift the keyboard off the laptop, careful of the IDE ribbon cable

    添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Pablo Andrade

于2018年02月14日注册

939 信誉积分

创作了7篇指南

团队

USF Tampa, Team S3-G1, Nance Spring 2018 USF Tampa, Team S3-G1, Nance Spring 2018 的会员

USFT-NANCE-S18S3G1

4 名成员

创作了8篇指南

添加评论

浏览统计数据:

过去的24小时: 4

过去的7天: 13

过去的30天: 48

总计 263