简介

This guide will teach you how to disassemble the device in order to replace the Keyboard.

  1. Power down the laptop and remove all power cords. After this is done, turn the laptop over.
    • Power down the laptop and remove all power cords. After this is done, turn the laptop over.

  2. Slide the battery latches outwards away from the center of the device.
    • Slide the battery latches outwards away from the center of the device.

    • The right latch will slide to the right, and left latch to the left.

  3. Lift and remove the battery from the device.
    • Lift and remove the battery from the device.

  4. Use the Phillips #1 screwdriver to unscrew the thirteen screws on the back of your device.
    • Use the Phillips #1 screwdriver to unscrew the thirteen screws on the back of your device.

  5. Remove the middle plastic cover to expose the hard drive.
    • Remove the middle plastic cover to expose the hard drive.

  6. 所有超过US$100或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店
  7. Using the Phillips #1 screwdriver, remove the two screws holding the hard drive in place.
    • Using the Phillips #1 screwdriver, remove the two screws holding the hard drive in place.

  8. Remove the three screws using the Phillips #1 screwdriver.
    • Remove the three screws using the Phillips #1 screwdriver.

    • Insert you fingers into the rubber ends and gently pull the hard drive out of the device.

  9. Use the Phillips #1 screwdriver to remove the two screws under the hard drive.
    • Use the Phillips #1 screwdriver to remove the two screws under the hard drive.

  10. Use a metal spudger and run it along the edges of the computer to take off the plastic back cover. (Starting near a port usually allows more space for the spudger to be inserted)
    • Use a metal spudger and run it along the edges of the computer to take off the plastic back cover. (Starting near a port usually allows more space for the spudger to be inserted)

  11. Slowly work from one end to the other to lift the back cover off.
    • Slowly work from one end to the other to lift the back cover off.

  12. Grab hold of the optical drive and elevate it slightly and remove it from the computer. Grab hold of the optical drive and elevate it slightly and remove it from the computer.
    • Grab hold of the optical drive and elevate it slightly and remove it from the computer.

  13. Using your thumb, apply a light amount of pressure to the underside of the keyboard until it pops out a bit. Using your thumb, apply a light amount of pressure to the underside of the keyboard until it pops out a bit.
    • Using your thumb, apply a light amount of pressure to the underside of the keyboard until it pops out a bit.

  14. Using the metal spudger, carefully pry up the edges of the keyboard.
    • Using the metal spudger, carefully pry up the edges of the keyboard.

  15. Shift the small tabs on either side of the ribbon outwards to release the end of the ribbon.
    • Shift the small tabs on either side of the ribbon outwards to release the end of the ribbon.

    • Gently remove the keyboard from the device.

结论

To reassemble your device, follow these instructions in reverse order.

Nicole Hague

于2018年04月10日注册

548 信誉积分

创作了4篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 6

总计 85