跳转到主内容

修复你的物品

维修的权力

配件 & 工具

简介

If your laptop begins making strange noises, like clicking or humming, has frequent program crashes or disk errors, or is exhibiting overall strange behavior, use this guide to replace your hard drive.

  1. Turn off your laptop before beginning.
    • Turn off your laptop before beginning.

    • Turn the laptop over so the base of the laptop faces the ceiling.

  2. Push the two plastic tabs retaining the battery into the chassis to each respective side.  This will push the battery up slightly and release it from the bottom of the notebook.
    • Push the two plastic tabs retaining the battery into the chassis to each respective side. This will push the battery up slightly and release it from the bottom of the notebook.

  3. 任天堂 Switch 套装

    快速恢复到游戏的状态

    购买 Switch 套装

    任天堂 Switch 套装

    快速恢复到游戏的状态

    购买 Switch 套装
  4. Using a finger or small prying device, pull the battery upwards from the recessed area. Then, simply pull the battery out of the notebook and gently set it aside.
    • Using a finger or small prying device, pull the battery upwards from the recessed area. Then, simply pull the battery out of the notebook and gently set it aside.

  5. Remove the two  3mm Phillips #00 screws holding the hard drive bay cover in place. Remove the two  3mm Phillips #00 screws holding the hard drive bay cover in place.
    • Remove the two 3mm Phillips #00 screws holding the hard drive bay cover in place.

  6. Remove the caddy by pulling it towards the left. This will disconnect the hard drive from the SATA interface. Then, simply pull the caddy out of the notebook
    • Remove the caddy by pulling it towards the left. This will disconnect the hard drive from the SATA interface.

    • Then, simply pull the caddy out of the notebook

  7. The hard drive will be held in the hard drive caddy by four 1.5mm Phillips PH00 screws.  Remove these screws to remove the old drive and install a new hard drive or solid state drive.
    • The hard drive will be held in the hard drive caddy by four 1.5mm Phillips PH00 screws. Remove these screws to remove the old drive and install a new hard drive or solid state drive.

结论

To reassemble your device, follow these instructions in reverse order.

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 3

总计 91