跳转到主内容

简介

This guide goes through the steps needed to install a new keyboard. Attention to detail is required in order to reverse the steps for instillation of a new keyboard, returning each screw to the correct location.

  1. Turn the computer over onto its back.
    • Turn the computer over onto its back.

  2. Slide the lock on the left side to the unlock position. Slide the lock on the right side to the unlock position until there is a clicking sound.
    • Slide the lock on the left side to the unlock position.

    • Slide the lock on the right side to the unlock position until there is a clicking sound.

  3. Remove the battery by sliding it out while both locks remain in the unlock position. Remove the battery by sliding it out while both locks remain in the unlock position.
    • Remove the battery by sliding it out while both locks remain in the unlock position.

  4. Use a plastic opening tool to unsnap the right hand side speaker cover. Use a plastic opening tool to unsnap the right hand side speaker cover.
    • Use a plastic opening tool to unsnap the right hand side speaker cover.

  5. PC 笔记本电池

    所有顶级PC品牌的电池均以我们的质量保证为后盾。

    现在开始购物

    PC 笔记本电池

    所有顶级PC品牌的电池均以我们的质量保证为后盾。

    现在开始购物
  6. Remove the rest of the cover by sliding it to the right and lifting the edge. Remove the rest of the cover by sliding it to the right and lifting the edge.
    • Remove the rest of the cover by sliding it to the right and lifting the edge.

  7. Use a Phillips head #00 screwdriver to remove the two silver screws at the top of the keyboard. Two 4.0 mm coarse thread screws.
    • Use a Phillips head #00 screwdriver to remove the two silver screws at the top of the keyboard.

    • Two 4.0 mm coarse thread screws.

  8. Remove the Torx screw holding the left keyboard tab in place, and lift it to release. One Torx T6 fine thread screw. One Torx T6 fine thread screw.
    • Remove the Torx screw holding the left keyboard tab in place, and lift it to release.

    • One Torx T6 fine thread screw.

  9. Turn the computer over on to the back. Remove the middle screw with a Phillips head #000 screwdriver.
    • Turn the computer over on to the back.

    • Remove the middle screw with a Phillips head #000 screwdriver.

    • One 7.5 mm fine thread screw.

  10. Turn the computer over to the front. Gently pull at the top and bottom to remove the keyboard.
    • Turn the computer over to the front.

    • Gently pull at the top and bottom to remove the keyboard.

    • Peel off the black tape that holds the connection wire.

  11. Flip the keyboard over and carefully unplug the connection wire. Reverse the steps for proper instillation of the new keyboard.
    • Flip the keyboard over and carefully unplug the connection wire.

    • Reverse the steps for proper instillation of the new keyboard.

结论

To reassemble your device, follow these instructions in reverse order.

Alison Wendt

于2013年04月18日注册

78 信誉积分

创作了6篇指南

团队

Cal Poly, Team 21-51, Johann Spring 2013 Cal Poly, Team 21-51, Johann Spring 2013 的会员

CPSU-JOHANN-S13S21G51

3 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 959