跳转到主内容
  1. Start by first removing the battery. Move the first release switch to the right position.
    • Start by first removing the battery.

    • Move the first release switch to the right position.

    • Move the second release switch to the right position while pulling the battery towards the top of the netbook.

  2. Using the bit driver and a Phillips #0 bit, remove the three circled screws, 5 mm in length.
    • Using the bit driver and a Phillips #0 bit, remove the three circled screws, 5 mm in length.

  3. While holding the top of the netbook, flip the netbook over. While holding the top of the netbook, flip the netbook over.
    • While holding the top of the netbook, flip the netbook over.

  4. Carefully lift off the power bar assembly for access to the button and receiver. Carefully lift off the power bar assembly for access to the button and receiver.
    • Carefully lift off the power bar assembly for access to the button and receiver.

  5. Use the spudger to gently pry around the keyboard. This will release the keyboard assembly from the body. Use the spudger to gently pry around the keyboard. This will release the keyboard assembly from the body. Use the spudger to gently pry around the keyboard. This will release the keyboard assembly from the body.
    • Use the spudger to gently pry around the keyboard. This will release the keyboard assembly from the body.

  6. Reach under the keyboard and disconnect the electrical connection. Lift the keyboard assembly out and away from the netbook.
    • Reach under the keyboard and disconnect the electrical connection.

    • Lift the keyboard assembly out and away from the netbook.

  7. Remove the two noted screws, 5 mm in length, with a bit driver and Phillips 3/16" tool. Remove the two noted screws, 5 mm in length, with a bit driver and Phillips 3/16" tool.
    • Remove the two noted screws, 5 mm in length, with a bit driver and Phillips 3/16" tool.

  8. Remove this electrical connection with tweezers. Use a spudger to gently pry the bezel from retaining clips.
    • Remove this electrical connection with tweezers.

    • Use a spudger to gently pry the bezel from retaining clips.

    • This will allow the keyboard bezel to lift off of the body.

  9. Use tweezers to remove the electrical connection to the old speaker assembly.
    • Use tweezers to remove the electrical connection to the old speaker assembly.

  10. Use a bit driver and a Phillips #0 bit to remove the two retaining screws on the speaker assembly. Lift out the old speaker assembly.
    • Use a bit driver and a Phillips #0 bit to remove the two retaining screws on the speaker assembly.

    • Lift out the old speaker assembly.

结论

To reassemble your device, follow these instructions in reverse order.

Mason McCaskill

于2013年10月18日注册

964 信誉积分

创作了9篇指南

团队

Clemson, Team 14-2, Benson Fall 2013 Clemson, Team 14-2, Benson Fall 2013 的会员

CLEM-BENSON-F13S14G2

3 名成员

创作了9篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 1

总计 350