简介

Use this guide to replace the Toshiba A1304T camera.

Using a thumb-tack, push-pin, or similar pin, remove the four plastic stoppers located on the back panel.
  • Using a thumb-tack, push-pin, or similar pin, remove the four plastic stoppers located on the back panel.

添加评论

With the T8 Torx Security Bit Screwdriver, remove the four screws in the designated locations.
  • With the T8 Torx Security Bit Screwdriver, remove the four screws in the designated locations.

  • The T8 Torx Security Bit Screwdriver can be substituted with a small flathead screwdriver. Screw removal may be slightly more difficult however.

添加评论

  • If needed, use the flathead screwdriver to gently pry the panel from the phone.

  • Using your fingers, lift the panel from the device.

添加评论

  • Using a small Phillips screwdriver, remove the two black screws from the positions indicated.

  • Gently pull the silver plate from the phone using your fingers.

添加评论

  • Using the head of a flathead screwdriver, flip the white segment of the socket that the camera's ribbon-wire runs into so that it is orientated vertically.

  • Gently lift the camera from its cavity and pull it away from the socket using your thumb and forefinger.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Christopher

于2010年04月22日注册

90 信誉积分

创作了8篇指南

团队

Cal Poly, Team 16-6, Maness Spring 2010 Cal Poly, Team 16-6, Maness Spring 2010 的会员

CPSU-MANESS-S10S16G6

4 名成员

创作了16篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 1,936