跳转到主内容

TomTom One XL Charging Port Replacement

你所需要的

  1. TomTom One XL Charging Port Replacement, Back Panel: 步骤 1 中的图像 1,2 TomTom One XL Charging Port Replacement, Back Panel: 步骤 1 中的图像 2,2
    • Remove the 4 .4mm screws on the back of the device.

  2. TomTom One XL Charging Port Replacement: 步骤 2 中的图像 1,1
    • Using the palate knife tool, pry the back from the LCD screen. Apply a moderate pressure to separate them.

    • You can rotate TOMTOM XL to make prying back off easier.

    • Be careful not to injure the two wires connecting the pieces.

  3. TomTom One XL Charging Port Replacement: 步骤 3 中的图像 1,1
    • After prying both halves apart, they will be connected by two wires.

    • Carefully set the two halves next to each other making sure not to stress or damage the wires.

  4. TomTom One XL Charging Port Replacement: 步骤 4 中的图像 1,2 TomTom One XL Charging Port Replacement: 步骤 4 中的图像 2,2
    • Using the tweezers separate the wires connecting the battery and speaker to the mother board.

    • Be gentle while pulling the wires out, the plugs are easily injured.

  5. TomTom One XL Charging Port Replacement, Charging Port: 步骤 5 中的图像 1,2 TomTom One XL Charging Port Replacement, Charging Port: 步骤 5 中的图像 2,2
    • If this is your first time solder then refer to IFixIt's safety guide.

    • Locate where the charger port goes on the circuit board.

    • Locate the four connecter on circuit board and charger port which need to be soldered.

    • Don't forget, the soldering iron is hot.

  6. TomTom One XL Charging Port Replacement: 步骤 6 中的图像 1,3 TomTom One XL Charging Port Replacement: 步骤 6 中的图像 2,3 TomTom One XL Charging Port Replacement: 步骤 6 中的图像 3,3
    • Using your plastic opening tool press down firmly on the top of the charger port.

    • While the soldering iron is hot press it again the four corners of the charger port.

    • Don't touch the charger port with your hands, it may have heated up during soldering.

  7. TomTom One XL Charging Port Replacement: 步骤 7 中的图像 1,3 TomTom One XL Charging Port Replacement: 步骤 7 中的图像 2,3 TomTom One XL Charging Port Replacement: 步骤 7 中的图像 3,3
    • Let the circuit board and charger port cool down for a few minutes.

    • Lift circuit board up, after making sure its cool, to see if four corners are all connected.

    • Plug in the charger to make sure it works, if not repeat steps and make sure the port is making a clean connection.

结论

To reassemble your device, follow these instructions in reverse order.

DeVhan

于03/11/15注册

401 声望

创作了4篇指南

团队

0条评论

添加评论

浏览统计数据:

过去 24 小时: 0

过去 7 天: 0

过去 30 天: 2

总计 2,402