简介

If your speakers have stopped working, this is the guide for you! It will show you how to replace your speaker with a new one.

Use a T-9 Torx screwdriver to unscrew the four screws on the back cover.
  • Use a T-9 Torx screwdriver to unscrew the four screws on the back cover.

添加评论

Using the spudger, gently pry apart the back case from the front case. It is easier to start on a side and work your way around the device.
  • Using the spudger, gently pry apart the back case from the front case. It is easier to start on a side and work your way around the device.

添加评论

  • Carefully pull the back cover apart from the front cover. Be careful not to pull too hard because there are two sets of wires connecting the device.

添加评论

  • Once the two covers are separated, use the tweezers, or even your fingers, to gently disconnect the two sets of wires that are connected to the motherboard from the back cover. You may have to wiggle the wires a little bit to get them to disconnect.

添加评论

  • Take the spudger and pry out the speaker.

  • When taking out the speaker, the entire plastic shock mounting casing will come out.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

2等其他人完成本指南。

Becca

于2010年04月16日注册

202 信誉积分

创作了2篇指南

团队

Cal Poly, Team 7-7, Maness Spring 2010 Cal Poly, Team 7-7, Maness Spring 2010 的会员

CPSU-MANESS-S10S7G7

4 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 14

总计 9,159