简介

The front cover can get chipped or scratched. In this case it should be replaced.

Use a T-9 Torx screwdriver to unscrew the four screws on the back cover.
  • Use a T-9 Torx screwdriver to unscrew the four screws on the back cover.

添加评论

Using the spudger, gently pry apart the back case from the front case. It is easier to start on a side and work your way around the device.
  • Using the spudger, gently pry apart the back case from the front case. It is easier to start on a side and work your way around the device.

添加评论

  • Carefully pull the back cover apart from the front cover. Be careful not to pull too hard because there are two sets of wires connecting the device.

添加评论

  • Once the two covers are separated, use the tweezers, or even your fingers, to gently disconnect the two sets of wires that are connected to the motherboard from the back cover. You may have to wiggle the wires a little bit to get them to disconnect.

添加评论

  • Next, you must remove the motherboard from the front screen.

  • Use a Torx T-7 screwdriver to unscrew the two screws.

添加评论

  • Before you can seperate the motherboard from the front cover, you must disconnect the wire connecting the two.

  • To do so, you must use the back end of the spudger to push out the two white tabs connected to the wire, that holds the motherboard and front cover together.

添加评论

  • Once separated, use the spudger to pry around the edges of the outer casing.

添加评论

  • Apply pressure with thumbs to remove screen from inner casing.

  • The screen and front cover are now disconnected.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Trevor Foster

于2010年04月18日注册

142 信誉积分

创作了3篇指南

团队

Cal Poly, Team 7-7, Maness Spring 2010 Cal Poly, Team 7-7, Maness Spring 2010 的会员

CPSU-MANESS-S10S7G7

4 名成员

创作了6篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 3

总计 4,093