简介

Use this guide to replace the motherboard of your Thustmaster Ferrari 458 Spider Racing Wheel.

  1. Remove the black 10mm using a JIS #1 screw driver.
    • Remove the black 10mm using a JIS #1 screw driver.

    • There are 12 screws.

    • Two of the screws are deep inside the device you might need to use a slim screwdriver.

    • In the picture you see a plastic opining tool instead of screw driver because we did not have our screw driver when we were taking the picture.

  2. 所有超过US$100或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店
  3. Remove the two 10mm black screws on the top of device using a Hex 2.5mm Key. Only the two outside screws. Gently pull apart both halves of device to access inside.
    • Remove the two 10mm black screws on the top of device using a Hex 2.5mm Key. Only the two outside screws.

    • Gently pull apart both halves of device to access inside.

  4. Using a small plastic opening tool, gently pry up the white connector that connects the USB cable to the board.
    • Using a small plastic opening tool, gently pry up the white connector that connects the USB cable to the board.

    • Cut the black cable as close to the board as possible.

    • Remove the three screws using PH2 screw driver.

结论

To reassemble your device, follow these instructions in reverse order.

Mohammed Alsogair

于2017年10月18日注册

222 信誉积分

创作了2篇指南

团队

USF Tampa, Team S1-G33, Cagle Fall 2017 USF Tampa, Team S1-G33, Cagle Fall 2017 的会员

USFT-CAGLE-F17S1G33

4 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 3

过去的7天: 12

过去的30天: 66

总计 1,383