跳转到主内容

配件

没有特定配件。

  1. Place The Claw machine in the up-right position with the control knobs facing you.
    • Place The Claw machine in the up-right position with the control knobs facing you.

  2. Turn The Claw machine upside-down placing the top cover on the surface of your work area.
    • Turn The Claw machine upside-down placing the top cover on the surface of your work area.

  3. Remove all ten 6mm phillips #1 screws underneath the top cover using your #1 phillips head screwdriver.
    • Remove all ten 6mm phillips #1 screws underneath the top cover using your #1 phillips head screwdriver.

    • It is helpful to choose a clear, well lit work space. There are multiple tiny screws that are easy to lose.

  4. Turn The Claw machine back to the upright position with controls facing you.
    • Turn The Claw machine back to the upright position with controls facing you.

  5. Remove the top cover of The Claw machine.
    • Remove the top cover of The Claw machine.

  6. Remove the ten 6 mm phillips #1 screws from the top flange. Remove the ten 6 mm phillips #1 screws from the top flange.
    • Remove the ten 6 mm phillips #1 screws from the top flange.

  7. Lift the flange upward and off to the side of the machine.
    • Lift the flange upward and off to the side of the machine.

    • There is enough wire connecting the flange to the machine that you will not need to cut the wire. The flange can be moved off to the side of the machine while you are working.

    • Cutting or ripping out the wire will cause damage to the machine so try not to put much tension on the wire.

结论

To reassemble your device, follow these instructions in reverse order.

Alain Pierre

于2016年03月22日注册

1,149 信誉积分

创作了9篇指南

团队

UMass Dartmouth, Team 4-8, Catania Spring 2016 UMass Dartmouth, Team 4-8, Catania Spring 2016 的会员

UMASSD-CATANIA-S16S4G8

3 名成员

创作了9篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 50