跳转到主内容

Tara Handle Replacement

  1. Tara Handle Replacement, Handle: 步骤 1 中的图像 1,1
    • Before performing any repairs, perform a water test on the pump by raising and lowering the handle a full 40 strokes. A properly performing pump will yield greater than 10 liters.

    • Use a Tara tool to loosen the jam nuts on either side of the pump.

    • The bolts do not need to be loosened or removed, only the nuts need to be loosened.

  2. Tara Handle Replacement: 步骤 2 中的图像 1,3 Tara Handle Replacement: 步骤 2 中的图像 2,3 Tara Handle Replacement: 步骤 2 中的图像 3,3
    • Unscrew the lock bolts about half an inch.

    • The bolts do not need to be removed from the base.

  3. Tara Handle Replacement: 步骤 3 中的图像 1,2 Tara Handle Replacement: 步骤 3 中的图像 2,2
    • Pull the plastic bushing and handle straight up out of the pump.

    • If the bushing doesn't come up, loosen the lock bolts further.

  4. Tara Handle Replacement: 步骤 4 中的图像 1,2 Tara Handle Replacement: 步骤 4 中的图像 2,2
    • Lift up the handle and riser main until the joint between the two is at a comfortable height to work on.

  5. Tara Handle Replacement: 步骤 5 中的图像 1,3 Tara Handle Replacement: 步骤 5 中的图像 2,3 Tara Handle Replacement: 步骤 5 中的图像 3,3
    • Loosen the jam nut beneath the pump handle using the Tara tool.

  6. Tara Handle Replacement: 步骤 6 中的图像 1,2 Tara Handle Replacement: 步骤 6 中的图像 2,2
    • Unscrew the pump handle from the top of the riser main.

    • Make sure someone is tightly holding the lower portion of the riser main to prevent losing it down the well.

  7. Tara Handle Replacement: 步骤 7 中的图像 1,2 Tara Handle Replacement: 步骤 7 中的图像 2,2
    • Lift and remove the handle from the pump. Store the handle in a sanitary place to prevent contamination.

结论

To reassemble your device, follow these instructions in reverse order.

Sam Goldheart

于10/18/12注册

465,252 声望

创作了538篇指南

团队

iFixit iFixit 的会员

Staff

136 名成员

创作了16,573篇指南

0条评论

添加评论

浏览统计数据:

过去 24 小时: 0

过去 7 天: 0

过去 30 天: 3

总计 200