简介

Use this guide when the directional pad needs to be replaced.

  1. Remove the four Torx T5 screws from the back panel.
    • Remove the four Torx T5 screws from the back panel.

  2. Wedge a spudger in between the front and back panel.
    • Wedge a spudger in between the front and back panel.

    • Apply leverage downwards to the spudger in order to remove the back panel.

  3. Slide the battery out from under the brown wire-tape.
    • Slide the battery out from under the brown wire-tape.

      • Be careful of the wires still connected to the other end of the battery. Do not pull or damage may occur.

  4. Slowly pull the white plug from its receptor. Grasp its sides firmly with a pair of tweezers and gently wiggle from side to side.
    • Slowly pull the white plug from its receptor. Grasp its sides firmly with a pair of tweezers and gently wiggle from side to side.

  5. 所有超过US$100.00或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店

    善于维修,即天赋异禀。

    与 #ImAGenius 分享您的维修故事

    我们都是天才

    与 #ImAGenius 分享您的维修故事

  6. Unscrew the 2 Philips #00 screws on each end of the motherboard.
    • Unscrew the 2 Philips #00 screws on each end of the motherboard.

  7. Pull off the black memory card slot piece.
    • Pull off the black memory card slot piece.

  8. Unscrew the 2 Philips #00 screws on each side of the charging port.
    • Unscrew the 2 Philips #00 screws on each side of the charging port.

  9. Disconnect 2 brown wire-tape ends from each end of the motherboard. Gently pull straight out with tweezers. Disconnect 2 brown wire-tape ends from each end of the motherboard. Gently pull straight out with tweezers.
    • Disconnect 2 brown wire-tape ends from each end of the motherboard. Gently pull straight out with tweezers.

  10. Grasp the upper left edge of the motherboard and slide diagonally up and left away from the auxiliary port entrance.
    • Grasp the upper left edge of the motherboard and slide diagonally up and left away from the auxiliary port entrance.

      • Glue connecting the port to the casing may make it difficult to remove. Gently apply force as needed.

  11. Unscrew the 2 silver Philips #00 screws from both sides of the directional pad component on the front casing.
    • Unscrew the 2 silver Philips #00 screws from both sides of the directional pad component on the front casing.

  12. Take out the 2 pieces of the directional pad with tweezers. Take out the 2 pieces of the directional pad with tweezers.
    • Take out the 2 pieces of the directional pad with tweezers.

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Daniel Wiseman

于2012年01月20日注册

127 信誉积分

创作了6篇指南

团队

Cal Poly, Team 10-33, Amido Winter 2012 Cal Poly, Team 10-33, Amido Winter 2012 的会员

CPSU-AMIDO-W12S10G33

4 名成员

创作了8篇指南

浏览统计数据:

过去的24小时: 0

过去的7天: 1

过去的30天: 1

总计 457