简介

This guide can be used to help replace a broken or stuck Doorbell located on the outside camera on your Swann Doorphone Video Intercom.

配件

无需配件。

Flip the outdoor camera over so that the underside is facing up.
  • Flip the outdoor camera over so that the underside is facing up.

  • Remove the back cover by grabbing the sides of the camera and pulling towards your body.

添加评论

With the back cover of the outdoor camera off, press the first gray button, with blue wire underneath, down as shown in the picture.
  • With the back cover of the outdoor camera off, press the first gray button, with blue wire underneath, down as shown in the picture.

  • While pressing the gray square button, remove the blue wire from the first opening under the button.

  • Be sure to remove the same color wire for the outdoor camera as was used for the indoor video intercom.

添加评论

  • Remove the other wires using the same steps as the blue wire.

  • Using the JIS #0 screwdriver, remove the 2mm screws from the back plate.

  • Remove the back plate by pulling the plate away from the device.

添加评论

  • Using the JIS #0 screwdriver, remove the 1mm screws from behind the camera.

添加评论

  • Using one of the tweezers from the Precision Tweezers Set, gently place them around the wire connector attached to the camera.

  • Pull slowly towards your body until the connector is no longer attached.

添加评论

  • Remove the camera from the device.

添加评论

  • Using your fingers, take hold of the wire connector attached to the main board

  • Pull slowly towards your body until the connector is no longer attached.

添加评论

  • Using the JIS #0 screwdriver, remove the 2 mm screws diagonal from each other from the main board.

添加评论

  • Gently pull the main board away from the inside of the device and leave to the side.

  • The main board will still be attached to the device by a remaining set of wires, but do not need to be removed.

添加评论

  • Using the JIS #0 screwdriver, remove the 1mm screws from each side of the doorbell spring-loaded cover-plate

  • While removing the second screw, hold down the cover-plate with your index finger to prevent the plate from springing out.

添加评论

  • Remove the black circular doorbell cover-plate.

  • Remove the metal circular doorbell button.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Joseph Kelemen

于2018年02月14日注册

227 信誉积分

撰写一个指南

团队

USF Tampa, Team S2-G4, Eyestone Spring 2018 USF Tampa, Team S2-G4, Eyestone Spring 2018 的会员

USFT-EYESTONE-S18S2G4

4 名成员

创作了5篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 4

过去的30天: 14

总计 94