1. Flip the phone over so that the screen is facing down.
    • Flip the phone over so that the screen is facing down.

  2. Push the gray lever up towards the top of the phone. Pull up on the battery pack and completely separate it from the phone.
    • Push the gray lever up towards the top of the phone.

    • Pull up on the battery pack and completely separate it from the phone.

  3. Locate the 5 screws around the back casing. Use a three-prong screw bit to remove all 5 screws
    • Locate the 5 screws around the back casing.

    • Use a three-prong screw bit to remove all 5 screws

  4. Use the plastic opening tool and slide it around the phone to pull apart the front and back casing.
    • Use the plastic opening tool and slide it around the phone to pull apart the front and back casing.

  5. 所有超过US$100或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店
  6. Separate the two cases.
    • Separate the two cases.

  7. Use the plastic opening tool to remove the motherboard from the front case.
    • Use the plastic opening tool to remove the motherboard from the front case.

  8. Locate the 4 white clips of the dispaly. Locate the 4 white clips of the dispaly.
    • Locate the 4 white clips of the dispaly.

  9. Using the plastic opening tool, pull the white clips of the display away from the printed circuit board to unclip display. Using the plastic opening tool, pull the white clips of the display away from the printed circuit board to unclip display.
    • Using the plastic opening tool, pull the white clips of the display away from the printed circuit board to unclip display.

  10. Grasp the display on both sides and carefully pull the display off of the printed circuit board. Grasp the display on both sides and carefully pull the display off of the printed circuit board.
    • Grasp the display on both sides and carefully pull the display off of the printed circuit board.

  11. Using the plastic opening tool, carefully remove the yellow film covering the display connector. Do not damage the yellow film. Ensure that it stays in one piece and does not tear.
    • Using the plastic opening tool, carefully remove the yellow film covering the display connector.

    • Do not damage the yellow film. Ensure that it stays in one piece and does not tear.

结论

To reassemble your device, follow these instructions in reverse order.

另外一个人完成了本指南。

Patrick Olmstead

于2013年10月22日注册

240 信誉积分

创作了2篇指南

团队

Clemson, Team 13-5, Benson Fall 2013 Clemson, Team 13-5, Benson Fall 2013 的会员

CLEM-BENSON-F13S13G5

3 名成员

创作了12篇指南

添加评论

浏览统计数据:

过去的24小时: 1

过去的7天: 1

过去的30天: 1

总计 120