简介

The PCG F360 comes with 64 MB of on-board RAM. An additional 128 MB can be added on for a total of 192 MB.

配件

无需配件。

  1. Position the laptop screen-side down as shown.
    • Position the laptop screen-side down as shown.

    • In this position the battery housing will be located on the right hand side.

  2. Lift the panel up and then out to gain access to the battery.
    • Lift the panel up and then out to gain access to the battery.

  3. Use the indentations to pull the old battery out.
    • Use the indentations to pull the old battery out.

  4. 所有超过US$100或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店
  5. The battery is now removed and it is safe to move on to uninstalling other components.
    • The battery is now removed and it is safe to move on to uninstalling other components.

  6. There are two screws on the left hand side of the laptop near the IR (Infared remote) receiver (see image). Remove them using a Phillips #00 Screwdriver. Slide the speaker panel towards the left, then carefully flip it over onto the keyboard. Make sure not to pull the speaker panel away from the computer just yet - it is still connected!
    • There are two screws on the left hand side of the laptop near the IR (Infared remote) receiver (see image). Remove them using a Phillips #00 Screwdriver.

    • Slide the speaker panel towards the left, then carefully flip it over onto the keyboard.

    • Make sure not to pull the speaker panel away from the computer just yet - it is still connected!

  7. On the inside of the speaker panel, using a spudger, push the beige tab in the direction of the ribbon. It should only move a small amount. Remove the ribbon by gently pulling on it, there should be little or no resistance. Now the speaker panel can be set aside.
    • On the inside of the speaker panel, using a spudger, push the beige tab in the direction of the ribbon. It should only move a small amount.

    • Remove the ribbon by gently pulling on it, there should be little or no resistance.

    • Now the speaker panel can be set aside.

  8. Remove the metal screw that will be located at the red circle. Pull on the green strip, and the keyboard should come free easily.
    • Remove the metal screw that will be located at the red circle.

    • Pull on the green strip, and the keyboard should come free easily.

  9. Slide your RAM into the housing by aligning it with the plastic, tan colored, guides until it is firmly in place.
    • Slide your RAM into the housing by aligning it with the plastic, tan colored, guides until it is firmly in place.

    • The computer in the picture only has the standard 64 MB of on-board RAM. This RAM is not removable from the motherboard, but additional RAM can be added.

结论

To reassemble your device, follow these instructions in reverse order.

ahintz

于2010年04月21日注册

19 信誉积分

创作了8篇指南

团队

Cal Poly, Team 16-3, Maness Spring 2010 Cal Poly, Team 16-3, Maness Spring 2010 的会员

CPSU-MANESS-S10S16G3

3 名成员

创作了8篇指南

浏览统计数据:

过去的24小时: 0

过去的7天: 0

过去的30天: 0

总计 1,561