简介

One of the common problems with the Sony SRS-XB30 is trouble syncing with the Bluetooth chip. This guide will give you step by step instructions on how to replace the Bluetooth chip.

To remove the speaker grill, insert the big spudger underneath it in each corner.
  • To remove the speaker grill, insert the big spudger underneath it in each corner.

  • Work around the edges to pry the grill up and off.

添加评论

With the Sony logo facing towards you, use the medium spudger to lift the side plates from the internal frame.
  • With the Sony logo facing towards you, use the medium spudger to lift the side plates from the internal frame.

  • This will need to be done on all four sides of the speaker to remove all four panels

  • This requires some effort because the adhesive is sticky.

添加评论

  • Locate the four screws on the now exposed front panel.

  • Using the screwdriver with bit T7, unscrew each screw (15.0 mm long).

添加评论

  • Next, remove the four outer edge screws, located on each corner of the speaker. The outer edge of the speaker is a clear plastic.

  • Use the same T7 screwdriver head here.

  • Remove each of the four corner screws (15.0 mm long).

添加评论

  • With a little force, carefully lift the lid of the speaker.

  • Make sure that you do not pull on the wires.

添加评论

  • Unclip the four wire connectors (that are attached to the speaker lid).

添加评论

  • Separate the speaker lid from the bottom frame.

  • To prepare the speaker for the next step place the lid parallel to the frame.

添加评论

  • Locate the two silver screws (9 mm) attached to the two LED-light-chips on the speaker lid.

  • Using the screwdriver with bit PH1, unscrew each screw.

添加评论

  • Separate the speaker lid entirely from the bottom frame.

添加评论

  • Remove the top screw (10 mm).

  • Use the screwdriver with bit T7.

添加评论

  • Locate and remove the three black screws (10.0 mm) within the internal frame. Use bit T7.

  • There are two screws on the left side of the white box and one to its right.

添加评论

  • Slightly lift the white box with all the wires still attached.

添加评论

  • Take the big spudger and pry the black casing up from the circuit box.

添加评论

  • Locate the blue film attached to the circuit box containing the charging port.

  • Detach the blue film from the box.

添加评论

  • Detach the yellow, black and red wires by pulling them directly up.

添加评论

  • Insert the spudger along the battery edge and firmly hold the wires. Lift both sides up. The battery will pop out from its encasement.

添加评论

  • To save time, pry up and remove the top panel first.

添加评论

  • Take the spudger and pry under the plastic square that the Bluetooth chip is directly attached to.

  • This will separate the plastic square from the lid.

添加评论

  • Remove the Bluetooth chip.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Star Dragon

于2018年04月09日注册

510 信誉积分

创作了3篇指南

添加评论

浏览统计数据:

过去的24小时: 7

过去的7天: 19

过去的30天: 53

总计 179