跳转到主内容

简介

The guide will demonstrate the steps necessary to replace a bad battery charging port with a new one. The speaker will be disassembled from a fully assembled condition by following the necessary steps listed in this guide to replace the faulty charging port. For this repair guide only a Phillips screwdriver and the replacement board are necessary. This replacement is very straight forward and very simple for a beginner.

配件

没有特定配件。

  1. Remove the 6 10mm Philips head screws shown, using  a PH1 screwdriver
    • Remove the 6 10mm Philips head screws shown, using a PH1 screwdriver

  2. Remove the 5 8mm Philips head screws shown. These are holding the battery and the green circuit board in.
    • Remove the 5 8mm Philips head screws shown. These are holding the battery and the green circuit board in.

  3. Lift the battery pack and circuit board out of the housing and locate the wires and ribbon connector shown in the figure.
    • Lift the battery pack and circuit board out of the housing and locate the wires and ribbon connector shown in the figure.

  4. Remove the ribbon connector and the connector from the battery pack                                                                                                                              (Note: These connectors are not easy to remove. Force may be necessary but the connectors are durable) After the connections are remove you are free to replace the circuit board.
    • Remove the ribbon connector and the connector from the battery pack (Note: These connectors are not easy to remove. Force may be necessary but the connectors are durable)

    • After the connections are remove you are free to replace the circuit board.

结论

To reassemble your device, follow these instructions in reverse order.

4等其他人完成本指南。

bradley

于2017年01月17日注册

209 信誉积分

撰写一个指南

10条评论

Bradley, this is a SONY 40BKB537U-CNF2G board….where can I get one? The mini charge port is bad on mine and v difficult to replace.

Thanks

michael ruse - 回复

Where can I buy the whole circuit board to replace the Charging port

Sony Mini speaker SRS - X3

40BKB537U - CNF2G

charging port

Morgan -

Where can I buy circuit board To replace charging port Sony Mini speaker SRS - X3

40BKB537U-CNF2G

Morgan -

Hi Michael, did you find a replacement board? I need to replace mine as well.

Julie Miller -

I have all the part of this speaker. Email me to negotiate! Kennyportillo99@gmail.com

kennycontreras44 -

添加评论

浏览统计数据:

过去的24小时: 5

过去的7天: 9

过去的30天: 45

总计 5,219