简介

If the device is having trouble reading disks, the laser may need to be replaced.

Remove the five exposed 7.9 mm phillips screws with the spudger.
  • Remove the five exposed 7.9 mm phillips screws with the spudger.

  • Punch through the warranty sticker with the spudger and remove the screw underneath.

添加评论

Remove the rubber feet with the screwdriver.
  • Remove the rubber feet with the screwdriver.

  • Remove the screws that the rubber feet were covering.

添加评论

  • Lift up the cover gently.

  • The tray is still connected to the base with wires.

添加评论

  • Remove the wires with tweezers by gently pulling on the base they are attached to.

添加评论

  • Remove the large connector.

  • Remove the small connector.

添加评论

  • Remove Philips screws with #0 Philips Screwdriver.

添加评论

  • Lift up the black piece connected to the wires.

  • Lift gently because ribbon cable is attached to bottom.

添加评论

  • Unlock the lock clip

添加评论

  • Remove the T6 screws with the T6 screwdriver.

添加评论

  • Gently pull rods out with tweezers.

  • Be sure the laser is out of the way so that the rods can be removed.

添加评论

  • Be careful when removing the rods because a fragile metal piece may break.

  • Pull laser off of the rods.

添加评论

  • Insert wisdom here.

添加评论

结论

To reassemble your device, follow these instructions in reverse order.

Oliver Woolsoncroft

于2012年01月20日注册

69 信誉积分

创作了2篇指南

团队

Cal Poly, Team 11-21, Maness Winter 2012 Cal Poly, Team 11-21, Maness Winter 2012 的会员

CPSU-MANESS-W12S11G21

4 名成员

创作了5篇指南

where do I buy the lens?

mnmmacd - 回复

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 2

过去的30天: 13

总计 4,028