简介

This guide will show you how to replace the motherboard on the Sony Cybershot DSC-W830 camera.

配件

无需配件。

  1. Open the battery cover by sliding it towards you. Open the battery cover by sliding it towards you.
    • Open the battery cover by sliding it towards you.

  2. Push the purple latch with your thumb to unlock the battery.
    • Push the purple latch with your thumb to unlock the battery.

    • Pull the battery out.

  3. Remove the eight Phillips #000 screws. Remove the eight Phillips #000 screws. Remove the eight Phillips #000 screws.
    • Remove the eight Phillips #000 screws.

  4. Remove the single Phillips #000 screw found next to the battery latch.
    • Remove the single Phillips #000 screw found next to the battery latch.

  5. 所有超过US$100或包含 Pro Tech工具包的订单免费送货!

    浏览我们的商店
  6. Remove the middle panel on the side of the device. Slowly pry the camera apart at its seem.
    • Remove the middle panel on the side of the device.

    • Slowly pry the camera apart at its seem.

  7. Disconnect all ribbon cables by using the flat end of a spudger to lift up the black tabs on the ZIF connectors. Once disconnected, use your fingers to lift lens out of the frame. Once disconnected, use your fingers to lift lens out of the frame.
    • Disconnect all ribbon cables by using the flat end of a spudger to lift up the black tabs on the ZIF connectors.

    • Once disconnected, use your fingers to lift lens out of the frame.

  8. Lift the power button board up off of the daughterboard. Lift the power button board up off of the daughterboard. Lift the power button board up off of the daughterboard.
    • Lift the power button board up off of the daughterboard.

  9. Remove the single Phillips #000 screw.
    • Remove the single Phillips #000 screw.

    • Use your hands to remove the blue daughterboard.

  10. Flip the camera around. Remove the  black and orange ribbon cables.
    • Flip the camera around.

    • Remove the black and orange ribbon cables.

  11. Remove the two remaining ribbon cables.
    • Remove the two remaining ribbon cables.

    • Pull the motherboard from the camera.

结论

To reassemble your device, follow these instructions in reverse order.

Saiman Sigdel

于2018年02月21日注册

157 信誉积分

创作了2篇指南

添加评论

浏览统计数据:

过去的24小时: 0

过去的7天: 2

过去的30天: 5

总计 74